Laser cutting machine is a modern commonly used processing equipment, in processing, there will always be some headache problems, encounter these situations, how should we deal with it? The following is a simple analysis of the reasons why the laser cutting machine is not normal.

Laser cutting machine since the use of there are a lot of precautions, laser cutting machine is not only the use of the process of the use of technology also need us to have a certain understanding, laser cutting machine often appear engraving and initialization problems, here you need to do a more positive data to solve the problem.

Laser cutting machine leakage, initialization is incorrect, sent data (correction); The order of operation is reversed (re-enter); Electrostatic interference (check whether the ground cable is off); Clean the hook side misalignment, not closed, check whether the software parameter Settings are correct (reset); Computer system error (reinstall operating system and software); Check whether the left and right belt tightness is consistent or whether the rear belt is too loose (belt tightening); Check whether the belt or synchronous wheel is slipping or skipping teeth (tighten the synchronous wheel or belt); Check that the beam is parallel (readjust the left and right belts).

Laser cutting machine reset abnormal reasons include the following aspects:

1. Laser cutting machine X axis and Y axis movement in the opposite direction, and impact the side end, this phenomenon to check whether the motherboard parameters are wrong, to stop to check whether the motherboard parameters Settings are wrong. 

2. Laser cutting machine control panel display normal, X axis and Y axis do not move, you can try to pull the sensor terminal of the motherboard, see if the machine has action, in this case to consider replacing the sensor. 

3. Beam reset normal, laser cutting machine X-axis reset does not move, the motor line may be broken or the motor shaft is broken, this phenomenon to replace the motor line or small motor.

4.Reset the direction is correct, but to the apex, the X axis or Y axis can not stop (first check the motherboard parameters), if correct, this phenomenon to check the motherboard or sensor, replace and exclude.